Atomsantics.com

There are 2 steps which you want to take to clean a large needle point rug. Also keep in mind that you may have some foot traffic patterns with which to be anxious.

First of all, you need to get some plastic sheeting to put beneath the rug if it isn’t on a water-resistant floor,eg vinyl. You’ll need some frothing carpet cleaner and a rug cleaning machine that doesn’t have rotating bristles. If the machine contains an upholstery tool, you may use that as long as it doesn’t have any rotating bristles. When it comes to cleaning a needlepoint rug, think of it as a big piece of upholstery that needs to be cleaned.

Before you use the frothing carpet protection cleaners, do a spot test in a little subtle location to make certain of its color fastness. Spray on the foam, then let it sit for ten or 15 minutes, then wipe it up with a damp rag. Don’t scrub the area ; wipe it up carefully. Do not continue if there is any color in the froth, apart from the mud from the surface. If the spot test turns out fine then you can use the foam on the other areas. Although the directions on the can may teach to clean the foam into the rug, do not do so with a yarn rug. Instead employ a damp material and work it around a little so that it will provide the surface with satisfactory coverage. Then let it sit for 10 minutes or so, then wipe the surface with a wet rag to take away the foam. Then wipe the surface rigorously with a little wetter rag, and wash it frequently.

After that spray adequate carpet protection foam over the whole rug so that it will spread from one end to the other. Do not spray a thick layer of froth, but only enough to cover it. Then work it around thoroughly with a wet fabric ( as before ), then let it sit for roughly ten mins. At that point, the froth should be nearly gone. Then go over the surface with the carpet machine and halfhearted water. Suck out as much water as feasible as the rug shouldn’t be sopping wet. Also, don’t rub hard on the surface of the rug when it is damaged as the yarns could get damaged.

The rug should dry as fast as possible. For the initial drying, you can hang it up outside over a line or railing. If you are not in a position to do so, put towels under the rug and set up a fan to blow across the top. When the rug is terribly close to becoming dry, take it off the line and lay it on the floor where it can dry flat. Do not walk on it or place furniture on it till the rug is completely dry.

Cotton fibers will weaken and eventually rot with time, so you need to remember that this may happen with your cotton rugs. Also, the rugs will be even more exposed to breaking or tearing when they are wet due to the extra weight on the threads. The condition of the rugs may be further damaged when they experience the agitation process in a washer, even if the machine is on the delicate cycle. So if the rugs are not clean enough after the 1st washing, you might need to use the old fashioned “boil” methodology. Boiling is the best means of cleaning a particularly old rug if the dirt is kind of stubborn , however , you may not be in a position to find a pan that’s large enough with which to boil the rug.

To divide long woven hall runners, you may cut across the width, not along the length of the rug. I you have tied fringes on the ends of the rug, you would need the new ends to look the same. In order to achieve this process, cut the rug, then unravel many rows of weaving so that you are going to get enough warp thread to tie in knots ; there will be some loss in the length of the rug. This process must be accomplished quickly or more rows will unravel. It is best to enlist the services of a friend who has done some weaving to help as you are prepared to cut. You’ll also accomplish this process by sewing across the end row using a heavy duty machine, which will actually minimize the raveling , however , the machine seam will be evident.

This entry was posted on Friday, October 2nd, 2009 at 11:07 pm and is filed under Home. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.